WG-25-KIT Cable Routing Kit for Starlink Mini, Gen 2 & Gen 3 — Silicone Wall Pass-Through
Product Type
Third-Party Compatible Cable Routing Kit
Grommet Material
Silicone
Grommet Inner Diameter
Approx. 7mm / 0.27 inch
Grommet Outer Diameter
Approx. 25.4mm / 1 inch
Grommet Length
Approx. 52.3mm / 2.06 inch
Included Tools
1 inch Spade Drill Bit, 5/16 inch Twist Drill Bit
Specifications
| Part No | WG-25-KIT |
|---|---|
| Product Type | Third-Party Compatible Cable Routing Kit |
| Grommet Material | Silicone |
| Grommet Inner Diameter | Approx. 7mm / 0.27 inch |
| Grommet Outer Diameter | Approx. 25.4mm / 1 inch |
| Grommet Length | Approx. 52.3mm / 2.06 inch |
| Included Tools | 1 inch Spade Drill Bit, 5/16 inch Twist Drill Bit |
| Package Includes | Wall Clips, Cable Ties, Silicone Grommets, Sealant, Drill Bits |
| Compatible Use | Starlink Mini, Gen 2, Gen 3 Standard |
Product Details
Silicone Wall Bushing Grommets
Four silicone grommets — roughly 25.4mm / 1 inch outer diameter, 7mm / 0.27 inch inner diameter and 52.3mm / 2.06 inches long — form a flexible, self-seating seal where cables pass through walls.
Waterproof Sealant Tube
The included sealant tube lets installers close any remaining gaps around the bushing after routing, helping keep moisture, drafts and insects out of the interior entry point and finishing the penetration properly.
Complete Drill Bit Set
Comes with a 1-inch / 25.4mm spade bit for the grommet hole and a 5/16-inch twist bit for pilot work, so the pass-through can be drilled with the supplied tooling alone. Specification: Grommet Inner Diameter — Approx. 7mm / 0.27 inch.
Multi-Generation Compatibility
Designed for cable routing use with compatible Starlink Mini, Gen 2 and Gen 3 Standard setups, the kit covers the most common residential, RV and camper installation scenarios with a single product.
All-in-One Install Kit
Wall clips, cable ties, grommets, sealant and drill bits arrive in one package — a complete cable management bundle that removes the need for separate tool purchases at the install site. Cable run is Approx. 52.3mm / 2.06 inch.
Application Scenarios
Home Wall Pass-Through
Drill a clean 25.4mm entry with the spade bit, seat a silicone grommet and route the dish cable into the house, sealing the gap with the included sealant tube.
RV & Camper Installation
Pass Starlink cables through RV walls or roof penetrations using the grommets and sealant, keeping the interior watertight during travel and campsite stays.
Office & Workspace Routing
Run cables between rooms or through partition walls with the 7mm inner-diameter grommets, tying off runs neatly with the supplied clips and ties.
Product Gallery
